Siemens SINAUT MD720-3, System Manual, Page: 35 / 76

SINAUT MD720-3 in Terminal Mode
SINAUT MD720-3
C79000-G8976-C211
35
AT&D Set circuit Data Terminal Ready (DTR) function mode
Executive command
Command: AT&D[<value>]
Response:
OK
Parameter: <value>:
0: Device ignores status on DTR. <Default>
2: ON->OFF on DTR: Disconnect call, change to command mode. During state
DTR = OFF is auto-answer off.
Notice:
-
AT&F Restore manufactory configuration
Executive command
Command: AT&F
Response:
OK
Parameter: <value>:
0: Restore parameters to manufactory values
Notice:
Restores the configuration of manufacturer of the following commands: ATE, ATQ, ATV,
ATX, AT&C, AT&D, AT\Q and ATS0.
AT&W Save stored profile
Executive command
Command: AT&W<n>
Response: OK
Parameter: <n>:
None Saving in Profile 0
0 Saving in Profile 0
Notice: This command saves the current configuration in a non volatile memory of the commands
ATE, ATQ, ATV, ATX, AT&C, AT&D, AT\Q and ATS0. The configuration can be reloaded
with ATZ. Before the first saving the profile is the same as the default configuration.
See also AT&V.
AT&V Display current configuration
Executive command
Command: AT&V[<value>]
Response: ACTIVE PROFILE:
<current configuration>
OK
Parameter: <value>:
0: only active profile
Notice:
The configuration is a text string on multiple lines as shown in the example below. As it is
dependant on the manufactory and user set-up, it is impossible to list the exact number of
information given.