Appendix
A.1 Assembly of cable terminals on the device side
SINAMICS CONNECT
92
Operating Instructions, 10/2018, A5E45421408
Assembling the terminals for cable with ferrule
Stranded conductor with insulated ferrule
(cross section: 0.25 mm
2
to 0.5 mm
2
)
Stranded conductor with non-insulated ferrule
(cross section: 0.25 mm
2
to 0.5 mm
2
)
1.
Remove the specified length (see illustration) of the outer sheath of the cable, and make a PE conductor from the
braided shield.
2.
Strip the specified length (see illustration) of the insulation at the end of the wire.
3.
Insert the stripped end into the pin-type terminal.
4.
Crimp the terminal using a crimping tool, and then cut off the excess part of the wire.