Siemens LOGO!, Manual

Page: 283 / 534

UDF (User-Defined Function) (0BA7 only)
LOGO!
Manual, 04/2011, A5E03556174-01
283
Setting the Par parameter
You can edit the Par parameter for your UDF block if you configured parameters for this UDF
using LOGO!Soft Comfort; otherwise, you cannot edit parameters for UDF blocks. In this
case, the UDF block display shows no "Par":
8
4
)
If your UDF block contains the Par parameter, you can edit the parameters as described
below:
View in programming mode (example):
8
4
,
3DU
1. Press to move the cursor to "Par" and press OK. LOGO! shows you the following
display (A and B are the identifiers you specified for the relevant UDF parameters in
LOGO!Soft Comfort . You can configure a maximum of eight parameters for each UDF
block using LOGO!Soft Comfort. LOGO! can show a maximum of three parameters on a
single display.):
8
$
%
2. "1/1" in this example means this is the first view of U1 parameters and U1 has a total of
one view of parameters. When you press OK, LOGO! show the following display:
8
$
%
3. Press or to change the plus sign into minus. Press or to select a number and
then press or to change the number. Press OK to confirm your changes. LOGO!
shows the following display:
8
$
%