Handset settings
32
KAP10.FM5
18.7.99
Gigaset 2011 Tango: A30852-X1106-B307-2-7619
Baby alarm
A registered handset can also be used as a baby alarm. If
this function is switched on, an internal call is made to a
second handset if noise above a specified volume is de-
tected. The call lasts approximately one minute and then
the baby alarm switches back to "BabyAlarm active" until
the noise level exceeds the specified level again.
Activating/deactivating the baby alarm
(
t
means: browse
x
,
confirm
u
)
or
To deactivate the baby alarm function, press the
display key.
Setting the volume level for the baby alarm
It is possible to set the voice level at which the baby alarm
function is activated.
(
t
means: browse using
x
,
confirm using
u
)
Z
OK
.t
Baby Alarm
o
The entry function is active (
➔
page 22). Enter the inter-
nal number to be called.
The baby alarm function cannot be used if the handset is
locked.
u
t
Store
W
u
t
Cancel
W
OFF
Z
OK
.t
Settings
t
Handset Settings
t
BabyAlarm Level
A value of 1 corresponds to a sensitive baby alarm,
whereas a value of 3 will require a higher volume to be ac-
tivated.
x
or
x
Set Alarm Level and
u
or
u
Store setting or quit without implementing changes.
>
<
OK
{
●
Do not place the handset in the charging
unit if the baby alarm is activated as the mi-
crophone will be covered.
●
This function must only be used if the bat-
teries are fully charged.
●
Standby times are reduced when the baby
alarm is activated.
●
Warning beeps, such as the battery and in
range warnings, should be deactivated be-
fore you switch on the baby alarm so that
the baby is not disturbed by them.
