Operating modes
7
KAP04.FM5
18.7.99
Gigaset 2011 Tango: A30852-X1106-B307-2-7619
When the handset is switched off:
Switching off the handset
Signaling method
The PTT operates telephone connections with two differ-
ent signaling methods:
●
Dial pulsing (DP)
●
Dual-tone multifrequency signaling (DTMF)
The factory default setting for your Gigaset 2011
Tango
is
DTMF.
Checking the signaling method of your telephone line
Setting the signaling method
(
t
means: browse using
x
,
confirm using
u
)
h
Press the handset key briefly. You will hear the positive
confirmation beep. The display flashes. Wait until it stops
flashing. The handset is switched on.
or
Place the handset back into the base station. The mes-
sage appears on the display. The handset is switched on.
h
Press the handset key
until
the display message is
cleared. You will hear the positive confirmation beep.
c
Press the off-hook key. You will hear the dial tone.
o
Press any digit, e.g. 2. If you still hear the same dial tone,
you must switch the signaling method to dial pulsing
(DP).
Z
OK
.t
Service
Call up the "Service" menu item.
#1
Start the setting procedure
o
Enter the four-digit base code (factory default: "0000")
(
➔
page 7).
u
@33x
Set to dial pulsing (DP).
or
u
@37 x
Set to DTMF. A flash time of 100ms is set.
REDIAL
SET
REDIAL
SET
