Commissioning
3.2 Flowmeter connection using RS-232
SITRANS FUH1010 Quick Start
Operating Instructions (Compact), 12/2008, CQO:QSG010 Revision A
19
10.
Within 10 seconds of power-up the main display will become active and an LCD display
screen for use with the Magnetic Wand will appear as shown below.
6LHPHQV;
&RS\ULJKW
①
LCD panel display showing initial screen with copyright notice.
3.2
Flowmeter connection using RS-232
RS-232 Connection
6HOHFW0HWHU7\SH
0HWHU7\SH
!6LQJOH&KDQQHO
0HWHU)DFLOLWLHV
6LHPHQV&KDQQHO>@&KDQQHO
Figure 3-2
Serial Port Program Menu Screen
Flowmeter Communications and Programming via the RS-232 Interface (optional)
Note
Refer to the flowmeter manual for programming the meter using the RS-232 Interface or see
Quick Terminal Mode Setup procedure below.
To use the RS-232 Interface to program the flowmeter instead of using the main unit display
you must be familiar with the basics of the Windows 95/98/NT/2000/XP HyperTerminal
communications program. Most PC computers provide at least one serial port using either a
9-pin or 25-pin D-type connector. The port designation can be either COM 1 or COM 2.
Usually, when a computer includes two serial ports, COM 1 will be the 9-pin connector and
COM 2 will be the 25-pin connector; however, port designations can vary. (See Quick
Terminal Mode Setup procedure.)