Configuration
4.13 Messages
CP 1243-7 LTE
102
Operating Instructions, 04/2017, C79000-G8976-C381-03
"Message parameter"
Here you configure the phone number or the recipient, the subject (e-mail) and the text of the
message.
"Trigger"
In the "Trigger" parameter group you configure triggering for sending the message and other
parameters.
●
E-mail trigger / SMS trigger
Specifies the event for which the sending of the message is triggered.
–
Use PLC tag
For the trigger signal to send the e-
mail, the edge change (0 → 1) of the trigger bit
"PLC tag for trigger" is evaluated that is set by the user program. When necessary, a
separate trigger bit can be configured for each message. For information on the trigger
bit, see below.
Resetting the trigger bit:
If the memory area of the trigger bit is in the bit memory or in a data block, the trigger
bit is reset to zero when the message is sent.
In all other cases, you need to reset the trigger bit with the user program.
–
CPU changes to STOP
–
CPU changes to RUN
–
Connection to a partner interrupted
Triggers the sending of the message when the connection to a partner is interrupted.
–
Connection to a partner established
Triggers the sending of the message when the connection returns.
–
Connection establishment to partner failed
Triggers the sending of the message when the connection to a partner could not be
established.
–
Teleservice session started
–
Teleservice session ended
–
Weak mobile wireless network
Only for SMS
If the mobile wireless connection for telecontrol communication is too weak, an SMS
message is triggered and sent to the configured recipient.
●
PLC tag for trigger
PLC tag for the trigger "Use PLC tag"
If the memory area of the trigger bit is in the bit memory or in a data block, the trigger bit
is reset to zero when the message is sent.
