Siemens CCMS2010-IR, User Manual, Page: 45 / 96

Camera settings
45
Siemens AB
Security Products 05.2014
schedule from the drop-down menu.
Motion Detection Setting
Users could adjust various parameters of Motion Detection in this section.
 Sampling pixel interval [1-10]:
This item is for users to define the intervals between the sampling pixels. The de-
fault value is 1. If the value is set as 3, it means within the detection region, system
will take the first pixel as the sample from every 3 pixels by each row and each
column (refer to the figure below).
 Detection level [1-100]:
The item is to set detection level for each sampling pixel; the smaller the value, the
more sensitive it is. The default level is 10.
 Sensitivity level [1-100]:
The default level is 80, which means if 20% or more sampling pixels are detected
differently, system will detect motion. The bigger the value, the more sensitive it is.
Meanwhile, when the value is bigger, the red horizontal line in the motion indica-
tion window will be lower accordingly.

Time interval (sec) [0-7200]:
The value is the interval between each detected motion. The default interval is 10.
Triggered Action (Multi-option)
The administrator can specify alarm actions that will take when motion is detected.
All options are listed as follows.
 Enable Alarm Output
Check the item and select the predefined type of alarm output to enable alarm re-
lay output when motion is detected.

Record Video Clip
Select this item and the Motion Detection recording will be stored in microSD /
SDHC card when motion is detected.
Pre-trigger buffer recording function allows users to check what happened to
cause the trigger. The pre-trigger buffer time range is from 1 to 3 seconds.
Select <Upload for __ sec> to set the recording duration after motion event occurs.
The setting range is from 1 to 99999 seconds.
Select <Upload during the trigger active> to record the triggered video until the
trigger is off.
NOTE: Please make sure the local recording (with microSD / SDHC card) is acti-
vated so that this function can be implemented. Refer to Recording for further de-
tails.
 Send Alarm Message by FTP/E-mail
The administrator can select whether to send warning messages by FTP and/or E-
mail when motion is detected.