Siemens Ardoptix PT 140 AF1, Operating Manual, Page: 20 / 68

s
Operating manual
12
11 Initializing emissivity ratio constants
The Ardoptix lets you store up to 10 emissivity ratio factors. Before you
perform a new measurement, simply use the
▲▼
control keys to select
your preconfigured emissivity factor. When you select a stored emissivity
ratio factor, the display will briefly show the preconfigured factor for that
emissivity ratio factor.
11.1 Define number of emissivity ratio constants in array
Before you configure the pyrometer with emissivity ratio factors, you
must define the size/length of the array. This is the number of emissivity
ratio you would like the array to contain (10 maximum). Using parameter
E.TB.Q
, enter the total number.
Measurement two-colour/ratio mode configuration layer C001
Parameter Function Explanation
E.TB.Q
Enter desired number
of elements in array
If
E.TB.1
=
OFF,
then use
▲▼
keys to manually set emis-
sivity ratio
11.1.1 Store and assign emissivity ratio constants
Next, assign a value to each emissivity ratio constant in the index.
Measurement two-colour/ratio mode configuration layer C001
Parameter Function Explanation
E. 01
Emissivity ratio
Memory position 1
z. B. 100.5 %
E. 02
Emissivity ratio
Memory position 2
z. B. 101 %
E. 03
Emissivity ratio
Memory position 3
z. B. 101.5 %
11.2 Select the emissivity ratio constant
The memory position can optionally be set using the menu.
Once you have configured the emissivity ratio parameter,
the pyrometer will maintain this specific setting. The py-
rometer will always operate with this value unless you
change the setting.