Siemens Ardoptix PT 140 AF1, Operating Manual, Page: 16 / 68

s
Operating manual
8
7.7 Automatic switch-off
In the default setting, the Ardoptix switches off automatically after 2
minutes if none of the control keys are pressed. Automatic switch-off can
be configured from 1
– 60 minutes. The Ardoptix measures continuously
when it is in "automatic disconnection deactivated" mode.
8 Setting parameters at the pyrometer (basic configura-
tion)
Use the buttons
▲▼ and the „MODE" button on the rear panel to access
and configure parameters. With these buttons you can view and adjust
all settings required for operating the pyrometer.
Menu structure:
1. Press the MODE button while in normal operating mode to switch
to "configuration layer" mode.
2. Use
▲▼
to select the configuration layer for the parameter you
wish to set.
3. Press MODE to confirm. Press
▲▼
to select the particular param-
eter.
4. Press MODE to confirm. Press
▲▼
to adjust the parameter value.
5. Press MODE again to end. Press
▲▼
to select
END.
Whenever a control key has not been pressed within 30 seconds, the py-
rometer will automatically return to normal operating mode. The modified
value is applied.

Normal
operating mode
(temperature)
Select
config. layer
C000-
C999
Select
parameter
EPS1
Adjust
parameter
99.9
MOD
E
MOD
E
MOD
E
▲▼
▲▼ ▲▼
Key lock may have been activated at the terminal. When select-
ing the configuration layer you will be prompted to enter an ac-
cess code with
P000
. To obtain full access to parameter set-
tings, enter
P100
otherwise you will only be able to view pa-
rameters but not change them.