INSTALLATION AND CONFIGURATION
2-50
Document No.: COM-00-05-16 June 2006, Revised June 2014
Version: C.1
Figure 2-66. Unknown Outbound Echelon Message Option
2.6.34
Telnet Password: Disabled
If a Telnet password has been defined for the WAG, an operator enters the password (maximum
of 20 characters) upon establishing a Telnet session, which will allow commands to be issued to
the WAG.
If a password is required, any time the operator enters a command, yet hasn’t offered the
password yet, the command that was entered will be ignored. If the operator persists in entering
commands, every third attempt the operator will be asked to offer the Telnet Password.
The WAG defaults this configuration setting to: DISABLED.
Figure 2-67. Telnet Password Option
2.6.35
RS485 J1/J2 Jumper Detect: Enabled
This configuration parameter is discussed in the Boot Monitor sections (2.4 and 6.2) of this
document.
The WAG defaults this configuration setting to: ENABLED.
