Siemens Nixdorf RM300 C20, Operating Manual

Page: 154 / 205

144
RM300 C Models U24801-J-Z146-2-7600
13
Equipment settings
13.1.2 Configuring the Bitronics interface
The Bitronics interface for the system printer can be addressed via the
/dev/cpt
special file.
13.1.3 Default settings for serial console monitors
To operate the system, you require either a graphical monitor or a serial terminal as
a console. The alphanumeric terminal is connected to the V.24 port of the first serial
interface.
This interface was configured during installation of the operating system on your
system. You must adjust the console settings to this configuration. Please refer to
the operating manual for your terminal for assistance. In addition to the default
settings given here, the terminals also offer non-relevant settings in the parameter
menus.
At least check the line speed set on your console terminal. A baud rate of
19200 must be set for console terminals. For information on how to set
the line speed, refer to the operating manual for your terminal.
Setting the console parameters for terminal type 9766
The console terminal must be set to the following values (host interface)::
During the installation phase the 9766 should be operated in firmware mode (vt220
emulation). In this mode only the international keyboard is supported.
To operate the 9766 in multiscreen mode, you must install the following packages
from the operating system CD using
SYSADM->Software_products
:
– DPTGUNIT
– CONS (from a secondary terminal, not from the console)
Baud rate: 19200
Parity: None
Data bits: 8
Stop bits: 1
i