Siemens Nixdorf RM300 C20, Operating Manual

Page: 101 / 205

Moving your system
8
U24801-J-Z146-2-7600 RM300 C Models
91
D
o
k
u
s
c
h
abl
on
en V
e
rs
io
n
3
.2
v
om
2
5
.10.
9
3
©
S
ie
m
en
s
N
ix
d
o
rf
I
n
fo
rm
a
ti
o
ns
s
y
s
te
m
e A
G
199
3
Dr
u
c
k
v
o
m
12
.
0
4
.1
9
99 15
:5
1.
01
P
fad:
H:
\C
h
ri
s
to
p
h
\M
anu
al
e\
P
D
F
\R
M
\R
M
3
00C
B
e
tr
iebs
an
le
it
ung
\eng
lis
c
h
\r
m
3
00.
k
0
8
Moving the system unit
Ê Before moving the system unit to another location, back up all the data stored
on the hard disks. For instructions on backing up data, refer to the Reliant UNIX
or SINIX V5.42 “System Administrator’s Guide”.
Ê Shut down the operating system.
Ê Remove any floppy disks, cartridges and CD-ROMs from the drives.
Ê Switch off the system unit and the peripherals and pull off all power plugs.
Ê Check that the connecting cables are marked in a way that will enable you to
reconnect them correctly.
Ê Disconnect all the cables.
Ê For safety’s sake you should transport each device separately.
Transport the system unit in its original packaging. Make sure that the system unit is
not subjected to any shock or impact in transit, as this may damage the hard disk
drive.
When installing the system unit at its new location, make absolutely sure
that the line voltage is set correctly.
Moving the monitor
Transport the monitor in its original packaging. In view of the risk of CRT implosion,
the monitor must be protected against mechanical impact.
Moving the peripherals cabinet
When moving the peripherals cabinet, take the same precautions as when moving
the system unit.
!