19
SRV285 TC
1.0.3 - 2015
Vedlikehold
NO
Maintenance
EN
» Kontroller at det til enhver tid er olje i oljetanken. Etterfyll med EP90
olje om nødvendig.
» Oljeskift bør skje hvert andre år. Kontroller oljekvalitet i girhus hver
gang båten er på land.
Når girolje i girhuset skal skiftes, må det
etterfylles samtidig som man drenerer, Dette for å sikre at girhuset ikke
går tomt for olje under byttet.
» Kontroller at de 2 boltene som holder girhuset sammen med braketten
fortsatt er godt tilskrudd (xx Nm).
» Hold propellen og girhuset fritt for algevekst ved å påføre bunnstoff før
hver sesong.
PS ! Anoder, tetninger og propellaksel skal ikke påføres bunn-
stoff, pass på så det ikke kommer bunnstoff i gjengesporene til
propellmutteren.
» Skift anoder før hver sesong, eller når ca. halvparten av anoden har
tæret bort. Bruk Loctite eller lignende på skruen til anoden for at den
ikke skal falle av. Ta i betraktning at under noen vannforhold er det
nødvendig å montere en ekstra anode for å være sikker på at de skal
vare i hele perioden mellom vedlikehold. Ta kontakt med din forhandler
for informasjon om hvordan å gjøre dette.
» Som en del av det periodiske vedlikeholdet av din båt, og før hver
sesong må følgende ting sjekkes:
• Propellen sitter godt festet.
• Boltene som holder elektromotoren til braketten sitter.
• Sjekk at aktuatoren ikke kan beveges mer enn 3mm i lengderetingen
ved innfestingen når manuell kraft påføres (Se Fig. 16).
Bytt bruddelementet om nødvendig (2 sett bruddelementer er inkludert)
• At universalleddet i retract-mekansimen er smurt
• Skottet der baugpropellen er montert skal være rent, og tørt. Hvis det
er vann i skottet må lekkasjen finnes og tettes.
• Alle elektriske tilkoblingspunkter er rene, og godt festet.
• Pass på at batteriene er i god stand slik at de kan gi høy spenning til
trusteren. Redusert spenning vil gi redusert effekt på trusteren.
» Make sure it is oil in the oil reservoir. Refill if necessary with gear oil
EP90.
» Change the gear oil every second year. Check the gear oil quality
every time the boat is out of the water.
When changing gear oil, refill
and drain gearleg simultaneously to secure that the system will not be
emptied.
» Check that the 2 bolts securing the gear leg to the bracket is still
tight (xx Nm).
» Keep the propeller and gearhouse clean from growth by painting
with antifouling before every season.
Note! The anodes, seals and propeller shafts must absolutely
not be painted. Be careful to not get paint in the “tracks”
in the gearhouse that the propeller hub moves in or on the threads
of the propeller nut
» Change the anodes (3) before every season. Always use a sealant on
the screw holding the anode to ensure that it does not fall off. Please
observe that in some waterconditions it can be necessary to install an
extra anode to ensure that it lasts for the whole period between regular
service lifts of the boat. Consult your dealer for information on how to
do this.
» As a part of the seasonal service of your boat, and before every
season, always check that:
• The propeller is securely fastened
• The bolts holding the electric motor to the motor bracket are
fastened correctly.
• The universal joint in the retract mechanism is lubricated
• Check for excess play in the break-away rings securing the actuator.
Spare rings are included from factory. If the actuator can be moved
more than 3 mm (ref. fig. 16) by manual force, replace the break-away
rings.
• The area where the thruster is installed is clean and dry. If there
are signs of water you must try to find the source and eliminate it.
• All electrical connections are clean and fastened firmly.
• Make sure that your batteries are in a good condition so the
thruster gets a good voltage. Old or bad batteries will give a
reduced performance from the thruster.
Check and relubricate
with waterproof grease if
neccessary
Anode,
gearleg
Check for wear in this area
Check for wear in this area
Max. 3mm
movement
Fig. 16
Anode,
retract
DO NOT apply antifoul-
ing or clean with any
kind of chemicals in this
area. Only clean with
water.
Part no. 140117 will
be worn and must be
replaced!