Commissioning and configuration
50
© SICK AG · Germany · All rights reserved · Subject to change without notice
8013889/ZML0/2017-06-09
Operating Instructions
NAV350 Laser positioning sensor
Chapter
6
6
Commissioning and configuration
The NAV350 must be commissioned only by adequately qualified personnel.
Before you operate a machine/system equipped with the NAV350 for the first time, make
sure that the system is first checked and released by qualified personnel. On this issue, ob-
serve the notes in
chapter 2 “For your safety” on page 10
.
Commissioning, configuration and diagnostics are undertaken using the SOPAS ET config-
uration software supplied.
6.1
Overview of the commissioning steps
•
Mounting and electrical installation must be undertaken.
•
Install SOPAS ET configuration software.
•
Establish communication with the NAV350.
•
Create a custom parameter set using SOPAS ET and save in non-volatile memory in the
NAV350.
•
Test NAV350 for correct function.
•
On usage for position output:
– Plan reflector positions and mount reflectors.
– Measure or teach-in reflectors.
– Enter positions of the reflectors measured or read positions from an ASCII file and en-
ter parameters for the reflectors in SOPAS ET.
•
On usage for landmark detection:
– Plan reflector positions and mount reflectors.
– Enter parameters for the reflectors in SOPAS ET.
