![background image](http://html.mh-extra.com/html/sick/1067380/1067380_operating-instructions-manual_1264216022.webp)
Inserting the memory card in the device:
NOTICE
Risk of damage to the memory card!
b
To avoid damaging the microSD memory card, make sure the device is
de-ener‐
gized
when you insert or remove the card. For this purpose, disconnect the device
from the supply voltage.
Access to the card slot
The card slot for the memory card is located under the hinged cover on the top side of
the device.
1.
Switch off the supply voltage to the device.
2.
Undo the screws (SW2 hexagon key) on the hinged cover and open the cover as
follows:
°
Carefully pull the upper edge of the cover away from the housing a little at the
level of the hinges on the side. Use both of the recesses on the inside of the
cover to do this.
°
Fold the cover upwards starting from the bottom edge.
3.
Making sure it is in the correct position, insert the memory card into the slot until
it locks into place. When doing this, position the contacts so that they are facing to
the rear and upwards, see the card symbol on the device.
4.
Close the hinged cover. Make sure that the cover is completely flush with the hous‐
ing.
5.
Tighten the screws on the hinged cover again.
6.
Switch on the supply voltage for the device.
Interpretation of the stored parameter set
Once it is switched on, the device automatically detects the presence of a memory card
and, depending on the memory card’s content, behaves as follows:
■
If the memory card is empty or contains a parameter set that cannot be inter‐
preted by the device, the device saves its currently valid internal parameter set to
the memory card (provided there is sufficient storage space). The device then
starts with its internal parameter set.
■
If the memory card contains a parameter set that can be interpreted by the device,
the device permanently overwrites the currently valid internal parameter set with
this external parameter set. The device then starts with its new valid parameter
set.
■
The goal is for the internal parameter set and the parameter set saved externally
to always be identical.
The highest-ranking parameter set is used by the device when operated in the
PROFINET with the following sequence hierarchy:
1
After starting, the device loads the last permanently stored internal parameter set
to its working memory.
2
The device then searches for a valid parameter set in the optional external mem‐
ory card slot. If there is a positive search result, the device overwrites the existing
parameter set in its working memory with this external parameter set.
3
If the PROFINET controller sends a parameter set via the PROFINET with central
configuration of the bus users, the device again overwrites corresponding parame‐
ter values in its working memory. These changes are lost again when the device is
switched off. The PROFINET controller must then again send the most recently
valid parameter values each time the device is restarted (supply voltage is
switched on).
3
PRODUCT DESCRIPTION
22
O P E R A T I N G I N S T R U C T I O N S | Lector63x Flex C-mount and S-mount
8018071/16XD/2020-05-06 | SICK
Subject to change without notice