1 695 656 076
2012-03-28
|
Sicam srl società unipersonale
52 | SBM 55 NW | Faults
en
Err
Possible causes
Remedy
21
The PCB has detected an excessively high wheel speed
with the wheel guard open (shaft rotating at high speed
although the machine has not been started): Power sup-
ply unit is deactivated
1. Switch off the SBM 55 NW .
2. Lower the wheel guard, switch the SBM 55 NW on
again without moving the wheel.
If the error message persists, contact customer ser-
vice.
22
Irregular measurement sensor signals
If the error message persists, contact customer ser-
vice.
EEE EEE
1. Two buttons are pressed at the same time.
1. Only press one button at a time.
If the error message persists, contact customer ser-
vice.
Summary of Contents for SBM 55 NW
Page 2: ......
