SIATA AQUA CUBIC MULTIPLEX, Use And Maintenance Manual

Page: 11 / 33

Aqua Cubic Multiplex
-
MAN0004 Rev. B 29.03.99
11/33
controller is therefore not in service, the remote start signal is ignored and the regeneration will be carried out at the
programmed time.
(3) The expression “The reg. starts at the time” means that the cycle starts at the programmed time even if the
programmed interval days have not passed or if it is not an active day for the start of the regeneration cycle.
6.2.1.b – Programming of the flags
Tab. 7 shows the options available for the modality
PPP0 :
Tab. 7 – Selection of the operative modality “one single column, PPP0”
FLAG
Display Operative state / Data visualised
PROGRAM
P 0 0 0 State of access to the selection of the operative modality
ENTER
P P P x Visualisation of the current operative modality (x = 0, 1, 2, 4, A)
2 / +
P P P 0
The key 2 / + modifies the operative modality as in tab. 4 : returns to 0
PROGRAM 0 H P
0 H P 0
Immediate regeneration by finished volume.
2 / +
0 H P
0 H P 1
Regeneration at the programmed time and deferred to the time by finished
volume.
PROGRAM
1 H P
1 H P 0 The interval days between two regenerations are programmed.
2 / +
1 H P
1 H P 1 The active days of the week are programmed.
PROGRAM 2 H P
2 H P 0 Immediate regeneration by Remote Start
2 / +
2 H P
2 H P 1
Regeneration deferred to the programmed time by Remote Start
PROGRAM 3 H P
3 H P 0
FLAG not used
PROGRAM 0 C P
0 C P 0
Modality of the litre counter divider (0 = free, see par. 6.6)
2 / +
0 C P
0 C P 1
Modality of the litre counter divider (1 = pre-programmed, see par. 6.6)
PROGRAM
1 C P
1 C P 0 FLAG not used
PROGRAM
2 C P
2 C P 0 The new programming is immediately operative.
2 / +
2 C P
2 C P 1 The new programming is operative after the next regeneration
PROGRAM
3 C P
3 C P 0 FLAG not used
PROGRAM 0 d P
0 d P 0
FLAG not used
PROGRAM 1 d P
1 d P 1
Enables the start and stop of the manual regeneration with the keys 1 and 0
PROGRAM 2 d P
2 d P 0
FLAG not used
PROGRAM 3 d P
3 d P 0
FLAG not used
PROGRAM
The rapid flashing of the display indicates that the values have been saved in
the eeprom.