T
-900 series Chapter 5 Equipment
0093142132-00
5-4
Install with four bolts
Bracket
Flat washer
Spring washer
M10 hexagon bolt
Radome (bottom)
Chassis
Accessory
Specification of bracket thickness-wise installation bolt (In case of radome antenna)
Thickness of bracket
Bolt for fixing the antenna
Material
Remarks
1 - 4 mm (0.04 – 0.16 in)
M10x15 (pitch 1.5mm)
stainless
4 - 9 mm (0.16 – 0.35 in)
M10x20 (pitch 1.5mm)
stainless
9 - 14mm (0.35 – 0.55 in)
M10x25 (pitch 1.5mm)
stainless
Included in accessories
14 – 19 mm (0.55 – 0.75in)
M10x30 (pitch 1.5mm)
stainless
Setting of Open Antenna
As illustrated below, install the drive block, facing the cut portion of the installation base toward the
stern. This makes it easier to perform the maintenance
1.
Referring to the illustration below, make holes of 14mm diameter on the installation side of
platform.
2.
Place the antenna block at the specified position and fix it with four 12mm stainless bolts included
in the installation material. If the thickness of the bracket is 9 – 14mm, the bracket can be installed
with the supplied bolts. If not within this range, prepare the bolts shown on the table in the next
page.
Unit: mm (inch)
199
(7.83)
(7.28)
(3.97)
(0.55)
185
Opening for cable
Cut portion of antenna base
HDG
Antenna raotational radius
R700 (4 ft antenna)
R500 (3 ft antenna)
