- 33 -
IR Connector (J4)
If you have an Infrared device, this mainboard can implement IR transfer
function. To enable the IR transfer function, follow these steps:
IR Pin Assignments:
1=VCC
2=NC
3=IRRX
4=GND
5=IRTX
Note:
Please make sure to refer on board IR Pin Assignments to match your
IR devices cable. Unmatchable Pin Assignment may do damage to
your IR device.
Step 1.
Attach the 5-pin infrared device cable to J4 connector.
(Refer to the above diagram for IR pin assignments.)
Step 2.
Configure the Infrared transfer mode in the UR2 Mode field of
integrated Peripherals menu in BIOS Setup. This mainboard
supports IrDA, ASKIR, Normal transfer modes.
Wake-on LAN Connector (J16)
Attach a 3-pin connector from the LAN
card which supports the Wake-On-LAN
(WOL) function. This function lets users
wake up the connected system through the
LAN card.
e1
e2
