11
Control Modes
There are 3 modes: • Select built-in programs
• Master/Slave
• DMX512
One Eventspot 1900 mkII (Built-in Programs)
When the Eventspot 1900 mkII is not connected by a DMX-cable and Wireless DMX is switched off, it
functions as a stand-alone device. See page 16/17 for more information about the built-in programs.
Multiple Eventspots (
Master/Slave control)
Use a 3-p XLR cable to connect the Eventspot 1900 mkII.
The pins:
1.
Earth
2.
Signal -
3.
Signal +
1.
Link the units as shown in (Fig. 4), connect a DMX signal cable from the first unit's DMX "out" socket
to the second unit's "in" socket. Repeat this process to link the second, third, and fourth units.
You
can use the same functions on the master device as described on page 16/17 (Built-in Programs
).
This means on the master device you can set your desired operation Mode and all slave devices
will react the same as the master device.
Multiple Eventspots
(
Master/Slave control)
DMX SLAVE SLAVE SLAVE
Fig. 4
Multiple Eventspots (Wireless DMX Control)
Make sure, the Eventspot is in WDMX mode. See page 20 for more details.
Multiple Eventspots (DMX Control)
Make sure, the Eventspot is not in WDMX mode. See page 20 for more details.
Use a 3-p XLR cable to connect the Eventspot(s) and other devices.
