ShowMagic AV, User Manual, Page: 122 / 233

2) Double-left-click on the ASIO selector button:
The lower part of the sound event panel will then change to display 8 audio channel faders
with their buttons labelled
01
to
08
. Above these you will find
File:
and
Channel:
descriptions.
3) The selected channel selector defaults to
01
. Clicking on the
File:
or
Dir:
(directory)
descriptions produces a
Load Wavefile
dialogue box.
4) Select the .wav file that you wish to play on Channel
01
.
5) Next - except on the SL Free Edition model where the output channels are fixed - you need
to select which physical audio mono channel, or stereo channel pair, that file will be played
on, so right-click to the right of
Out:
and select the physical channel from the pop-up menu.
6) Click on the channel
02
fader to highlight it and repeat steps 3 to 5 above to load the
appropriate wave files on to the other channels.
7) If you want to access channel faders
09
-
16
(not available on the SL Free Edition model) then
use the page selector buttons in the bottom left.
8) The levels for each channel can be adjusted by using their appropriate faders as normal.
9) Stereo Pan Button - If you are playing any audio files on a stereo output then the stereo pan
position can be set by clicking on the
Pan
button - this will temporarily replace the volume
faders with pan faders for each track - these faders can then be used to adjust the pan
position for that track. Clicking on the
Pan
button again removes the pan faders - replacing
them with the volume faders.
10) Finally right-click anywhere in the lower area, or click on the
Exit
button, to return to the
normal sound panel buttons display.
Playing and Routing .wav Files
To play and route a .wav file to a specific output on a multiple output soundcard do the following:
1) Highlight a sound event button by clicking on it.
2) Double-click on the ‘wave’ type selector button. A file selector appears.
3) Select the appropriate file and click on
Open
, the file details will then be shown in the
details display.
4) Right click to the right of
Aud: Wave
to select the required stereo or mono output(s).
If you have loaded a stereo .wav file and you select one of the stereo outputs e.g.
Stereo 1 & 2
, then
output
1
will play the left stereo audio and output
2
will play the right stereo audio. If however you
select a single mono output e.g.
Mono 1
, then the left and right stereo audio will be automatically
‘combined’ by ShowMagic and played out to mono output
1
.
110
ShowMagic SLX Series User Manual