Shopseries RK7866, Manual

Page: 10 / 32

4˝ BELT / 6˝ DISC SANDER ENG
10
SYMBOLS
Read the manual
Warning
Wear ear protection
Wear eye protection
Wear dust mask
n
o
No-load speed
TECHNICAL DATA
Voltage 120V~60Hz
Amps 4.3A
Belt length 4˝ x 36˝
Belt table tilt range 0
O
/90
O
Belt speed 1700fpm
Disc size 6˝
Disc speed 3600/min
Table size 8-29/32˝ x 6-5/16˝
Table tilt range 0-45
O
Weight: 42lbs
OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the instruction
book carefully.
ASSEMBLY
WARNING: Remove the plug from the socket
before carrying out any adjustment,
servicing or maintenance.
1. MOUNTING THE BELT/DISC SANDER TO WORKBENCH
(SEE FIG.A)
If belt/disc sander is to be used in a permanent location,
it should be fastened securely to a firm supporting
surface such as a workbench.
If mounting to a workbench, holes should be drilled
through supporting surface of the workbench.
1) The unit should be bolted securely using M8 screws
and hex nuts (not provided). Screw length should be
about 1.5” plus the thickness of the bench top.
2) Locate and mark the holes where belt/disc sander is
to be mounted.
3) Drill 2 holes of 0.4” diameter though workbench.
4) Place belt/disc sander on workbench aligning holes
drilled in workbench.
5) Insert two M8 screws and tighten hex nuts.
2. ASSEMBLING SANDING DISC AND GUARD (SEE FIG.
B1-B3)
1) Remove the backing from the sanding disc (6). Align
perimeter of disc with sanding plate (3) and press disc
firmly into position all the way around.
2) Locate disc guard (a) and two M4.2 pan head screws.
3) Position disc guard against lower 1/3 of disc, aligning
holes.
4) Using a Phillips screwdriver, fasten the pan head