10
How to distinguish the placement of corner connection parts and position
of the masking roller.
Drawing 4-5 (Viewed from the back of the frame.)
Motor side
Tail plug side
Corner connector 1
Corner
connector 2
Corner connector 1
Corner
connector 2
M6
M6
M6
M6
FRAME ASSEMBLY PROCEDURE
Step 1: Put the inner and outer frame parts according to the layout in drawing 5-1-1.
All parts have corresponding numbers attached to them.
•
The frame section parts are labeled as per drawing 5-1-1.
•
For smaller frames, the numbers are corresponding to the number of parts that make out the
frame, always starting with part 1 from the right short side. For example, for a <3m non-divided
frames, the total number of components of both the outer and inner frame is 4 (per frame
section), the right short side has #1, the lower long side has #2, the left short side #3 and finally
the upper long side #4.
