16
Step 5: Installation of the masking system (can also be done retrospectively).
•
The left supporting bracket (viewed from behind) should be the one with the round hole in it.
The bracket with the square hole is placed on the other side holding the motor. Please await
securing the position of the left bracket.
Drawing 5-5-1
•
Install the brackets so that the masking roller can be installed mid positioned. Keep the left side
bracket (with the round hole) a little loose to allow for the roller to be installed.
•
Pull out about 20cm of masking fabric manually.
•
Install the masking roller into the bracket, first by securing it on the right (motor) side.
Then install into the left (round hole) side and secure the bracket.
•
In case you need to adjust the mechanical stop points on the motor, the adjustment holes
should be oriented towards the back so that they are accessible. Please note that these
mechanical points are set at the factory, so they should normally not require any
further adjustments.
Drawing 5-5-2
Outer frame
Roller
Masking fabric
Bottom bar
200~300mm
Motor adjustment
hole
Right supporting
bracket
Left supporting
bracket