8
2.
Please attach the included 3M double sided tape to the masking roller, just below the small step
found in the roller.
3.
Place the roller tube with the motor side to the left and tail side to the right. Please note that
when installing the masking roller into the frame later on, this direction is opposite (seen from
the back of the frame), i.e. the motor is on the right side and tail on the left.
4.
Install the fabric flush with the edge at the left side and install it towards the right as per
drawing 4-3. There will be an approximate gap of 5mm left on the right (tail) side.
For the 2.40:1 2-way masking systems, please attach the left side flush, but use a 5mm gap
on the right (tail) side as well, as per drawing 4-5.
Masking fabric
Edge of the masking fabric
Edge of the roller
Drawing 4-3
Step
Drawing 4-4
Step
Masking
fabric
