39
6.2.5 Printing Gap Correction
This is a function to correct the gap between the penpoint and the end of the tracing.
When setting this function ON, chart paper for the whole printout contents is automatically sent
to the position in front of Pen 1 after the asynchronous printout is completed. (Fig. 6.2.5)
The printout contents can be checked.
For this function, only DI asynchronous printing and asynchronous log printing are available.
Fig. 6.2.5 Printing gap correction
6.3 How to Record
6.3.1 Starting/Stopping Recording
To start/stop recording, press the “REC” key.
To stop, press the “REC” key for 3 seconds or longer.
The “REC” indicator goes off when recording stops.
6.3.2 Feeding the Chart Paper
The chart paper is fed while the “FEED” key is pressed, and stops when released.
[Note]
(1) When the power is turned on, the recorder continues from the state in which it was turned off.
(2) When controlling recording start/stop through Digital Input (DI function, option: RE1),
recording start/stop cannot be switched by the “REC” key.
(3) When recording stops, No.1 pen (red) holds a left-side position (approx. 15 %) and No.2 pen
(green) a right-side position (approx. 85 %) respectively. Paper feed is suspended, but the
FEED key movement is enabled.
Pen 1
• Printing gap correction OFF
12:00 STOP MEAS.
• Printing gap correction ON.
Gap Correction
12:00
STOP MEAS.
Pen 1
Summary of Contents for HR-700
Page 1: ...HYBRID RECORDER HR 700 PEN WRITING INSTRUCTION MANUAL ...
Page 122: ...121 ...
Page 123: ...122 ...
