Shining3D Aoralscan 2, User Manual

Page: 14 / 108

14
Intraoral Scanner User Manual
• Do not use the scanner if its tip or cable is damaged. Contact technical
support for replacement of the damaged equipment (see Contact
information on chapter 1 ).
• To avoid risk of electrical shock hazards, always inspect the scanner and
cable connections before use.
• Check the cable housing before use. Do not use if the housing is damaged
or the cable is abraded.
• All devices connected to the Aoralscan 2 shall comply with IEC 60601-1 and
IEC 60950.
EMC notice
Electromagnetic emissions
Medical electrical equipment such as the Aoralscan 2 requires special
precautions regarding electromagnetic compatibility, and must be installed and put
into service according to the following electromagnetic tables.
The
Aoralscan 2 is intended for use in the electromagnetic environment specified
below. The customer or user of the Aoralscan 2 should assure that it is used in
such an environment.
Table 2-3 Guidance and manufacturer’s declaration – electromagnetic emissions
Emission
measurement
Conformity Electromagnetic environment -
guidelines
RF emissions
CISPR 11
Group 1
The Aoralscan 2 uses RF energy only
for its internal function. Therefore, its RF
emissions are very low and are not likely
to cause any interference in nearby
electronic equipment.
RF emissions
CISPR 11
Class B
The Aoralscan 2 is suitable for use in
all establishments, including domestic
establishments and those directly
connected to the public low-voltage
power supply network that supplies
buildings used for domestic purposes.
Harmonic emissions
IEC 61000-3-2
Class D
Voltage fluctuations/
flicker according
IEC 61000-3-3
Complies