33(44)
Note: Press the pressing block and blade when you remove the
last screw so to avoid personal injuries.
3. Install the blades
Clean carefully the fixed blades and rotating blades and then install them.
1) Install the rotating blades
2) Then the fixed blades
3) Finally the front fixed blades
Note: Each time to replace the blade, the screw and insulation
ring must be replaced also.
Note: Inject screw thread fixing glue (light blue LOCTITE 243
recommended) to the fixing screw so to avoid slipping and
tighten screws up.
6.2 Installation of Bearing and Cutter Shaft
1) Install the bearing 2. bearing washer 1. bearing sleeve 7 into the bearing
base 3.
2) Insert the blade shaft 4 into the bearing sleeve vertically 7.Then sleeve the
staggered blade 5 and the teeth blade 6 on the bearing spacing.
Picture 6-4: Installation of Bearing and Cutter Shaft 1
3) Put the Cutter Shaft 2 into the cutting chamber 1, let both terminals of the
bearing tallies with the grooves.
