![background image](http://html1.mh-extra.com/html/shindaiwa/dgw340dm/dgw340dm_owners-and-operators-manual_1257949045.webp)
- 42 -
Error Display
Error codes are displayed on the DC and AC meters when the control board detects
an error.
If the error code is displayed, follow to the procedures in the "Remedy".
Error
Code
Symptom
Remedy
E01
Overheating of
control parts for
welding
Set the idle control switch to "AUTO" or "ECO".
Run the engine to cool it down at idle under no-load until the
"E01" display disappears.
*This error is automatically resolved when temperature of the
control parts lowered to normal.
E03
Short circuit
of the weld output
Stop the engine.
Return the short circuit of the weld output and restart the engine.
E14
Short circuit of
automatic
switching weld
output
Stop the engine.
Return the short circuit of the weld output and restart the engine.
<Note>
•
Maintenance of this equipment must be performed by specialized technicians.
•
When performing maintenance with doors or covers open, be sure that no other
persons can accidentally come close to the equipment. Close all doors and covers
if momentarily leaving the equipment unattended.
•
A simple inspection cannot always resolve some problems. If you cannot resolve a
problem after inspecting the equipment, request repair at the retail outlet where
the equipment was purchased.
Summary of Contents for DGW340DM
