Shindaiwa DGW340DM, Owner'S And Operator'S Manual

Page: 14 / 52

- 11 -
The equipment includes a spill containment (structure that collects leaking liquid)
in order to prevent leaking liquid from getting outside of the equipment if oil, fuel
or other liquid should leak. Before starting operation, check if there is any fluid
accumulated in the spill containment and drain any accumulated liquid. (Refer to
section "11.(7) Draining Liquid from the Spill Containment".)
<Note>
•
It is necessary to periodically drain the liquid from within the equipment because
any rainwater that leaks into the equipment also accumulates in the spill
containment.
•
Although the fluids that can leak internally consist of oil, fuel and cooling water, the
spill containment does not have a function that can separate rainwater that has
leaked into the equipment from these internally leaked fluids. Properly dispose of
liquid drained from the spill containment in a manner according to the applicable
laws and regulations.
5-4. ECO Drive
The equipment includes an eco drive function in order to reduce noise, save fuel,
and reduce exhaust gas emmision.
When the idle control switch is set to "ECO" and only welding is being performed,
the engine operates at an optimal speed corrsponding to the weld output and it
automatically returns to low speed when welding is stopped.
The eco drive display lights up during eco drive to indicate that operation is
environmentally considerate.
<Note>
•
If using for only welding, the engine will attain the optimal speed to match the weld
output when you start to weld.
•
If using only as an AC power source, the engine speed will attain a uniform speed
that is slightly less than the rated speed.
•
The engine speed changes to high speed
when simultaneously welding and using
as AC power source.
•
Speed automatically returns to low speed
when not using for welding work or as an
AC power source.
•
Set the idle control switch to "HIGH" if
using a high capacity motor, precision instruments or AC load with an attached
magnetic switch.
•
Set the idle control switch to "HIGH" when using a device of 1A or less because
the engine might not reach a high speed as the speed control function does not
operate at that level.
•
Set the idle control switch to "LOW/HIGH" or "HIGH" if welding or using as an AC
power source in an intermittent manner.
•
Set the idle control switch to "LOW/HIGH" or "HIGH" if simultaneously performing
high-current welding and using as an AC power source.
Idle Control Switch Eco Lamp