Shindaiwa DGW340DM, Owner'S And Operator'S Manual

Page: 22 / 52

- 19 -
5-13. Remote Control (Option)
You can connect the remote controller to the remote control connector to enable
remote operation of weld current adjustment.
1) Connect the plug of the extension cord (cord reel) into one of the dedicated
remote control connector (side A or B).
2) Connect the plug of the remote controller into the receptacle of the extension
cord (cord reel).
Up to 3 cord reels (30m x 3) can be connected.
<Note>
•
The output control dial for the remote control connection side of the equipment
does not function when a remote controller is connected.
•
If the remote controller is removed from the remote controller receptacle while
welding, the equipment output control dial becomes functional, possibly resulting
in a sudden increase or decrease in weld output.
•
Do not connect the remote controller plug to the receptacle of an extension cord
(cord reel) that is connected to AC100/110V. Improper connection causes the
caution lamp of the remote controller to light up indicating a fault.
•
Do not connect the receptacle of an extension cord (cord reel) used for the remote
control to any other device besides the remote controller.
•
Set the breaker to "ON" if the cord reel is equipped with one.
Warning: Electric Shock/Injury
•
Do not operate the equipment if the equipment or your body is wet.
•
Always be sure to stop the engine and remove the starter key before performing
any equipment check or maintenance.
•
Do not operate the equipment with any doors or covers open. There is a danger of
hair, body parts and other items being caught up in moving parts such as cooling
fans and belts.
Warning: Fire
•
Always be sure to wipe up any spilled fuel or oil.
•
Spilled fuel and oil accumulates in the spill containment. Do not operate the
equipment with liquid accumulated in the spill containment.
•
Absolutely never use the equipment if there is a fuel, oil or cooling water leak, and
be sure to always repair the leak before using.
•
Absolutely never inspect or perform maintenance to the equipment near fire or
other open flame.
Caution: Burn
•
The engine, muffler and similar parts are extremely hot during operation and
immediately after stopping the equipment. Never touch hot parts.
6. Pre-Operation Inspection
Remote Control Connector
Caution Lamp
Remote Controller