Shindaiwa DGW340DM, Owner'S And Operator'S Manual

Page: 28 / 52

- 25 -
 Restarting after Stopping due to Running Out of Fuel
The equipment includes an automatic air-bleeding device. You can easily restart
the engine according to the following procedures even if the engine stops due to
running out of fuel.
1) Turn the breaker to "OFF".
2) Turn the starter switch to "STOP" position.
3) Add fuel to the fuel tank.
4) Set the idle control switch to "ECO" or "AUTO".
5) Turn the starter switch to "START" position and crank the starter motor for
approximately 10 sec.
6) After the engine starts, remove your hand from the starter switch.
7) Wait for air to be completely bled from the fuel pipes and engine speed to
stabilize (approx. 1 minute).
*Engine speed is not stable until all air is bled from the fuel pipes.
<Note>
•
Do not switch the engine at high speed or apply any loads to it until all the air has
been bled from the fuel pipes (until speed is stable). Doing so can cause a
malfunction.
7-2. Stopping the Engine
1) Turn the breaker to "OFF".
2) Set the idle control switch to "ECO" or "AUTO".
3) Allow the engine to cool down for approximately 5 minutes.
4) Turn the starter switch to "STOP".
5) After the engine stopped, turn the fuel lever to "CLOSE".
<Note>
•
Do not stop the engine while welding or using as an AC power source. Doing so
can cause a malfunction.
•
If the engine does not stop when the starter switch is set to "STOP", turn the fuel
tap to "CLOSE". The engine will stop a few minutes afterwards. If the engine does
not stop by starter switch operation, stop using the equipment and request repair
at the retail outlet where the equipment was purchased.
8-1. Welding Cable Selection
Use welding cables with a cross-sectional area that is larger than the proper
cross-sectional areas indicated in the table below.
Using cable that is less than the proper cross-sectional area reduces the weld
output.
<Note>
•
Use welding cables when they are completely extended (not coiled). Using a cable
that is coiled reduces the weld output.
8. Using as a Welder