Shindaiwa DGW340DM, Owner'S And Operator'S Manual

Page: 38 / 52

- 35 -
Inspection Item
Pre-
Operation
Inspection
Inspection Period
50th
hour
Every
100
hours
Every
200
hours
Every
400
hours
Every
1000
hours
Every
2000
hours
19
Inspect/Replace Fuel/
Cooling Water/Oil Hoses,
Anti-Vibration Rubber,
and Upper/Lower
Packing of Fuel Tank

or 1 year
(Inspec-
tion)

or 2 years
(Replace-
ment)
20
Adjust/Lap Clearance of
Air Intake/Release Valves

Adjust-
ment

Lapping
21
Inspect/Adjust Clearance
of Fuel Injection Valves

22
Inspect/Adjust Fuel
Injection Pump

23
Clean/Inspect Spill
Containment 
or 1 year
(1) Changing the Engine Oil
1) Remove the oil plug.
2) Remove the oil drain plug and
drain the engine oil.
3) Tighten the oil drain plug.
4) Add oil through the inlet port, while checking the oil level using the oil gauge,
until it reaches the maximum level. (Fill with approx. 3.5L.)
5) Tighten the oil plug.
<Note>
•
Refer to section "6-1. Engine Oil Inspection" for the types of engine oil.
•
Replace the packing of the oil drain plug with a new part each time the oil is
changed.
•
Packing part no.: 6C090-58961 (Kubota part no.)
•
After tightening the oil drain plug, operate the engine for a short period to check
there is no oil leakage. Stop the engine when completed.
(2) Changing the Oil Filter
1) Drain the engine oil according to the procedures of
"(1) Changing the Engine Oil".
2) Remove the oil filter using a filter wrench.
3) Apply a thin layer of oil to the gasket of a new oil
filter.
4) Screw in the oil filter by hand and securely tighten
by hand (do not use a filter wrench) after the gasket
contacts the seal surface.
5) Add engine oil. (Fill with approx. 3.5L.)
1st time 50th hour
2nd time and after Every 100 hours
1st time 50th hour
2nd time and after Every 200 hours
Oil Filter
Oil Inlet Port
Oil Plug
Oil Gauge
Oil Drain Plug
Gasket