Shindaiwa DGM60MK, Owner'S Manual

Page: 29 / 48

26
9. Operating Procedures
9-1. Initial Startup/Pre-Check
WARNING : EXHAUST GAS POISONING
Do not operate the generator in poorly ventilated areas such as an indoors or
tunnels, as the exhaust gas of the engine contains substances that are
harmful to human health.
Do not direct exhaust fumes at bystanders or buildings.
WARNING : INJURY
Always be sure to check that the breakers on load side and switches for any
equipment using the generator are at OFF before turning the breaker to ON.
Also be sure to advise personnel on the load side that power will be turned
on before operating the breaker.
Close all doors and lock them during operation.
CAUTION : FIRE
Do not bring flammable items (such as fuel, gas and paint) or items that are
highly combustible near the generator as the muffler, exhaust gas and other
parts become extremely hot.
Position this generator 3 ft. (1 m) or more from walls or other hindrances, and
on a level surface.
CAUTION : NJURY
Do not operate the generator if it has been modified or any parts have been
removed.
Position the generator on a level stable surface so that it cannot slide or
move in any manner.
Before starting operation, always be sure to turn off all switches of equipment
being used and all breakers to OFF.
Turn the three-phase and single-phase breakers on the operation panel to OFF.
Turn the Throttle switch to IDLING.
Turn the Starter switch to PREHEAT.
When the pre-heating indicator changes from lit up to off, immediately change the
switch to START and start the engine.
< NOTE >
Pre-heating time depends on the coolant
temperature, and completes in
approximately 0.5 to 15 sec.
Do not continuously operate the starter
motor for 10 sec. or more.
If repeating starter switch operation, wait 30
sec. or more between operating.
Be aware that smoke might be generated
when the engine is started.
1
4
2
3
Throttle
Switch
Pre-Heating
Indicator
Starter
Switch
3-P Breaker
1-P Breaker
Voltage
Regulator