Shindaiwa DGM60MK, Owner'S Manual

Page: 12 / 48

9
5. Equipment
5-1. Available Output Monitor
The available generated output for each output power source is displayed digitally. You can
use the display selector switch to change the display in the following order: three-phase,
single-phase three-wire U-W output, and single-phase three-wire U-N/G output. Three-phase
output is constantly displayed when the engine is stopped.
< NOTE >
Consider the digitally displayed available output as an
approximate estimate. Be especially sure to thoroughly
consider the displayed value and the used load capacity when
using a load such as that of a motor with a large starting
capacity.
The displayed output capacity might not be correct values if
using a four-wire connection (single-phase using the N/G
terminal) for a three-phase output power source. Connect to a
single-phase/three-line type power source if using a
single-phase power source.
If “- -” is displayed for the available output, it means that usage
has exceeded the rated capacity. Immediately stop the equipment being used and reduce the
load capacity of the equipment.
5-2. Warning Indicators
This generator is equipped with the following warning indicators: BATTERY (battery charge),
OIL PRESS (engine oil pressure), WATER TEMP (coolant temperature), OVER SPEED
(engine overspeed), AIR FILTER (air cleaner clogging), SPILL CONTAINMENT (spill
containment amount), and ENGINE (engine malfunction). An indicator lights up if a
malfunction/fault occurs during operation and the engine automatically stops depending on the
fault type. Moving the starter switch from STOP to RUN causes the following indicators to light
up for approximately 0.5 sec.: OIL PRESS, WATER TEMP, and ENGINE.
WARNING : INJURY
Do not open the check door during operation. Be careful of pinching or
catching of moving parts such as the cooling fan and fan belt.
Always be sure to stop the engine and remove the engine key when
performing inspection or maintenance.
CAUTION : BURNS
Do not touch the engine and surrounding components immediately after
stopping the engine as they are still hot.
Display Selector
Switch