Shindaiwa DGK14F, Owner'S And Operator'S Manual, Page: 36 / 50

33
(2) Replacing the Oil Filter
First Time 50 hours
Thereafter Every 200 hours
Drain the engine oil. (Refer to section
“(1) Engine Oil Replacement”
.)
Remove the oil filter using a filter wrench.
Spread a thin layer of oil on a new oil filter gasket.
Thread the oil filter by hand, and turn by hand (do not use a
filter wrench) from when the gasket contacts the seal surface
until it is securely tightened.
Add engine oil to the generator.
Shortly after starting the engine, always be sure to check that
there is no oil leaking from the seal surface.
< Note >

Request the authorized distributor where the generator was purchased to perform this procedure
if you do not have a filter wrench.

Oil filter part no.: 16414-32434 (Kubota part no.)
(3) Air Filter Element Cleaning/Replacement
First Time
(clean)
50 hours
Thereafter
(clean)
Every 100 hours
Replace
once in 6 times cleaning
or Every 1 year
Remove the air cleaner clips and cleaner cap.
Remove the element.
Clean or replace the element. Replace by performing the above procedures in reverse
order.
< Note >

Always be sure to turn the cleaner cap in the direction
indicated by the arrow.

Replace the elements earlier if using in an excessively
dusty location.

Do not add oil as this generator uses a dry element.

Clear foreign material by pinching the vacuator valve once
a week in normal operating conditions or daily if operating
in a location that is excessively dirty or dusty. Wipe away
any dirt or moisture that has adhered to the parts.

Never touch the elements for any reason except cleaning.

Element part no.: TA040-93231 (Kubota part no.)
1
1
2
3
Gasket
4
6
2
3
5
Air Cleaner Cap
Air Cleaner
Clip
Vacuator Valve
Air Cleaner Cap
Air Filter Elements