Shindaiwa DGK14F, Owner'S And Operator'S Manual, Page: 17 / 50

14
①
Speed
Displays the engine speed. 1800rpm is displayed at 60
Hz.
②
Water Temp
Displays the temperature of the engine coolant.
Normal temperature displayed during operation
should generally between 158°F (70
℃
) and 203°F
(95
℃
) depending on usage.
< Note >

If the coolant temperature rises above 212°F (100°C), immediately stop all connected equipment
to the generator, and idle the engine while cool down the coolant temperature.
③
Oil Press
Displays the pressure of the engine lubrication system. Normal pressure displayed during
operation should generally 35 and 57 psi (2.4
－
3.9 x 100 kPa) depending on usage.
However, the pressure may rise above this range just after starting a cold engine. Idle the
engine until it reaches the normal pressure.
(3) Fuel Meter
It shows the amount of fuel in the tank.
All lamps are lit when the amount reaches to the maximum level, and FULL is
lit.decreases .The lit lamp decreases as the amount of fuel in the tank reaches to EMPTY.
The fuel level on the control panel will only display the fuel level for the internal fuel tank.
Generator Meters and Gauges
(1) Voltmeter
The voltmeter displays the single-phase output
voltage(voltage between U-W). Check that
240V at 60Hz is displayed during operation.
Indicators
(1) Glow Lamp
This lamp illuminates when the starter switch is on START
positon. This lamp turns off when pre-heating is completed.
This lamp turns off and the generator starts.
< Note >

Pre-heating completes in approximately 5 seconds.
(2) Pilot Lamp
This lamp illuminates when the engine is operating to indicate
that power is being generated.
Hour Meter
時間計
Oil Press
Water Temp
Fuel Meter
Speed
Selector
Switch
Pilot Lamp
Glow Lamp
Starter Switch