Shindaiwa DGA50CM, Owner'S And Operator'S Manual, Page: 46 / 52

42
(2) Stacking
Follow the guideline below, when performing any troubleshooting. If you cannot resolve the
problems by this troubleshooting guide, contact our authorized distributor or our engineering
section to request the repair.
WARNING : Injuries
If you have to stack two generators at warehouse, always proceed with the
following steps.
 Ensure that there is no dent on bonnet, loose bolt or no bolt in the equipment.
 Always place the equipment horizontal on a flat and stable surface to be
endurable for the total weight, and to keep the equipment from sliding.
 When lifting the equipment, always use a lift hook.
 Always place ties (sleepers) on the lower equipment firstly and then stack
the upper equipment on it. All the ties should be the same size (dimension)
and longer than the width of the lower generator.
 Do not stack more than 2 units. The lower generator should be bigger than
the upper generator in size and weight.
 Do not operate the stacking/stacked equipment.
WARNING : Electric Shock
 Do not operate the equipment, if the equipment or you are wet.
 Before performing any equipment check or maintenance, stop the engine
.
CAUTION : Injuries
 When performing equipment check and maintenance, always stop the
engine.
CAUTION : Fire/Burns
 Never get fire near to the equipment.
 When checking engine oil or changing oil, always stop the engine, and
wait until the engine cools down.
If you open either the oil gauge or the oil filler cap during operation,
hot oil may cause some injury.
12 Troubleshooting