Shindaiwa DGA50CM, Owner'S And Operator'S Manual, Page: 39 / 52

35
(1) Change engine oil
Remove the Oil Filler Cap.
Remove the Oil Drain Plug and then turn
The Oil Drain Lever to OPEN and drain
engine oil.
Turn the Oil Drain Lever to CLOSE
and tighten the Oil Drain Plug.
Add oil through oil filler to fill it up to the
MAX level while checking the oil level on
the oil level gauge.
Tighten the Oil Filler Cap.
< Note >
 For the volume and the type of engine oil to use
and to replace, refer to
『
8-1. Checking Engine
Oil
』
.
(2) Oil Filter Change
Drain the engine oil fully, as described
in (1) CHANGE ENGINE OIL.
Loosen and remove the oil filter, using
an oil filter wrench.
Smear a little engine oil on the rubber gasket of the new oil filter.
Screw a new filter into place and tighten
it by hand until the gasket contacts the
seat. Then, give it additional 2/3 turns,
using an oil filter wrench after the gasket
touch the seal surface.
Supply engine oil.
Initial 50 hours
2
nd
and after Every 200 hours
1
2
3
4
5
Initial 50 hours
2
nd
and after Every 400 hours
1
2
3
5
4
Oil Drain Plug
Oil Gauge
Oil Filler
Oil Drain cock
Drain Plug Oil Filter
Gasket