Shimano Alfine S7000 Series, Dealer'S Manual

Page: 19 / 47

19
To be continued on next page
INSTALLATION
Installation of the shifting cable
2
(A)
Loosen and remove the wire end
hooking cap.
(A)
Wire end hooking cap
3
(A) (B)
Insert the inner cable into the groove in
the winder unit, and then pass it
through the hole in the cable adjustment
barrel.
(A)
Hole in cable adjustment barrel
(B)
Groove in winder unit
4
(A) (B)
Pull the inner cable so that the inner
cable drum fits into the hole in the
winder unit.
(A)
Inner cable drum
(B)
Hole in winder unit
5
(A)
(C) (B)
Screw in the wire end hooking cap as
shown in the illustration until it stops.
If it is turned any further, it will damage
the screw thread in the cover.
In addition, the unit cover may become
bent, which may cause an obstruction
between the unit cover and the main
lever, and the main lever may not
operate correctly.
If the main lever does not return
properly, loosen the wire end hooking
cap slightly to make a gap between the
main lever and the unit cover, and check
that this improves the returning of the
main lever.
(A)
Wire end hooking cap
(B)
Unit cover
(C)
Main lever