Shimano Alfine S7000 Series, Dealer'S Manual

Page: 29 / 47

29
INSTALLATION
Installation of the shifting cable
Disconnecting the shifting cable when removing the rear wheel from the frame
(A)
Disconnect the cable from the cassette
joint when removing the rear wheel
from the frame.
(A)
Cassette joint
1
Set the shifting lever to 11 .
2
(A)
Press the lever of the pulley clockwise to
loosen the inner cable. In the following
steps 3 and 4, continue to work in this
condition.
(A)
Pulley lever
3
(C)
(y)
(z)
(B)
(D) (E)
(A)
Remove the outer casing holder unit
from the outer casing holder of the
cassette joint
(y) .
Remove the inner cable the rubber
bellows is attached to from the slit in the
bracket
(z)
. Be careful not to damage the
rubber bellows at this time.
(A)
Rubber bellows
(B)
Outer casing holder
(C)
Outer casing holder unit
(D)
Bracket
(E)
Slit
4
(A)
(B)
Remove the inner cable fixing bolt unit
from the cassette joint pulley.
(A)
Inner cable fixing bolt unit
(B)
Cassette joint pulley
NOTE
If reinstalling the cable, refer to steps 4 to 7 in
"Cassette joint end".