Shimadzu ATX-R Series, Instruction Manual, Page: 113 / 160

112
V
Convenient Functions Relating to Output
10
CONNECTION AND COMMUNICATION WITH PERIPHERAL DEVICES
2
Select the auto print function.
[APL.PRN] [AUTO.PRN]
What is the current situation? What do you want to do?
Stability
Mark
Auto Print
Function
To Set / Update To Cancel
Lit ON
Press and go to step
3
.
Press and go to
step
5
.
Unlit OFF
Press and go to
step
3
.
Go to step
5
.
3
Select the mode for output timing.
Select the output timing from among mode 1 to
mode 5 (see the table on the previous page).
(Select the mode.)
[SET]
As an example, assume here that mode 3 is
selected (output with a stable positive value or a
stable zero indication).
4
If necessary, set zero return
requirement.
[Z.RET] [RET. 0]
or
[RET. 50] [SET]
What is zero return requirement?
After the previous sample (item to be
weighed) has been removed from the pan,
the weight reading must fall below the
zero value and stability must be achieved
before the next sample is placed on the
pan, otherwise there will be no automatic
output for this next sample. This function
is intended to prevent two or more outputs
being made for the same sample. For the
zero return value, select either zero or 50%
of the weight of the immediately preceding
sample. Setting 50% saves time because
even if the display doesn't return to zero, as
long as stability is achieved, output will be
possible if the next sample is placed on the
pan.
If you are not setting zero return requirement, proceed to step
5
.
A!U!T!O.P!R!N
Check the presence or absence of
the stability mark.
! !L!D. ! .Z
! !S!E!T!
! ! !Z.R!E!T
•
When "RET. 0" is set:
! !R!E!T. !0
! !S!E!T!