Shibaura ST318, Workshop Manual

Page: 76 / 247

75
3) Disassembly, inspection and reassembly
T197
➀
Remove the connecting lead which connects the
magnetic switch and the yoke.
➁ Remove two thru bolts, which tighten the yoke to
the housing, from the end frame side.
➂ Remove two screws (end frame-to-brush holder) to
remove the end frame.
➃
Remove the two (+) side brushes from the brush
holder.
➄
Remove the brush and remove the yoke from the
housing.
NOTE: Do not damage nor put oil on the brush
and commutator.
➅
Remove the armature form the housing.
➆ Remove two screws (magnetic switch-to-housing)
to remove the housing.
➇ Remove the clutch from the housing.
NOTE:
1. Do not damage the clutch bearing.
2. Never disassemble the magnetic switch. (If the
switch is found to be defective, replace as a
magnetic switch assembly.)
3. Never loosen the nut at the magnetic switch
contact bolt (terminal bolt).
T198