Shibaura ST318, Workshop Manual

Page: 183 / 247

182
9. Install the bearing race (18), needle bearing (19) and
bearing race (18) in the housing.
10. Insert the spool in the sleeve and align the spring’s
ditch.
11. Install two flat spring (17) in the spring’s ditch end.
12. Install the centering springs between flat springs at the
one time.
13. Install the retaining ring (15) on the centering springs.
14. Apply the grease between the retaining ring and sleeve
for prevent fall down.
15. Install the pin in the sleeve.
16. Install the sleeve and spool assembly in the housing
and as follows:
➀
Keep the housing to vertical when install the spool
and sleeve assembly.
➁
Keep the sleeve center parallel to housing center
when installing. If not parallel them will be bite in
the housing.
➂
Keep the pin to horizontally and insert them while a
little bit rotate clockwise and counterclockwise.
➃ Inspect the sleeve and spool assembly is rotate in
the housing at align the housing end with sleeve
and spool end.
T620
T621
T622
T623