11
End
Voltage (arc length) final current (crater filling). Exclusively for MIG modes S2T and S4T.
Range: -50 - 50%
FORCE
ARC FORCE.
Exclusively for MMA and MMA PULSE. Range: 0 - 100%.
freq
The frequency of the pulse.
Only for the method of D-Pulse MIG, TIG PULSE and PULSE MMA. Range: PULSE TIG, pulse MMA: 0,1 - 99 Hz;
D-Pulse MIG 0.5 - 5 Hz.
Hoti
Hot Start (MMA) / initial current (MIG / MAG)
MMA:
Hot Start By HoTI control parameter is the current value by which the welding current is increased.
The adjustment range depends on the type of material and the diameter of the welding wire.
MIG / MAG:
Initial current.
Only modes S2T I S4T.
The adjustment range depends on the welding method, the type of welded material and wire diameter.
Hott
The duration of the function HOT START (MMA) / time of the initial current (MIG / MAG)
MMA:
The duration of the HOT START function.
Range: 0 - 99 ms.
MIG / MAG:
The duration of the initial current. S2T only mode.
Range: 0 - 50 sec.
Hotu
Voltage (arc length), the initial current. Exclusively for MIG / MAG modes
S2T I S4T. Range: -50 - 50%.
INDIUM
Inductance - the adjustment of the arc can be optimized depending on the thickness of the work piece, the method and
the welding conditions. Only for MIG / MAG welding. Range: -99 - 50%.
P-p
Peak current.
Only D-Pulse MIG, TIG PULSE and PULSE MMA
Range: MIG / MAG 5 - 50%, PULSE 1 TIG - 500% MMA PULSE 1 - 50%.
Load
Number of loaded set of parameters.
fast
Post-gas - the time that the continued flow of the shielding gas is the extinction of the arc. Only for MIG / MAG
welding. Range: 0.1 - 50 s.
preg
Pre-gas - the time during which shielding gas flows before the arc ignition. Only for MIG / MAG welding. Range: 0 - 10
sec.
PU
Voltage (arc length) peak current. Only methods for D-PULSE
MIG. Range: -50 - 50%.
save
Number saved parameter set
slop CC
Arc characteristics - constant current mode. Only for MMA.
slop CP
Arc characteristics - constant power mode. Used for welding cellulosic electrodes. Only for MMA.
Sptt
The duration of spot welding.
Only for MIG / MAG welding spot SPOT mode and CPOT. Range: 0.1 - 9.9 sec.
StFd
Wire feed speed before arc ignition. The adjustment range 1 - 15 m.
Stop
The time interval between cyclic zajarzeniami arc. Only for MIG / MAG welding in continuous spot welding
CPOT