-55
Appendix
Removing and Installing
the Lamp Unit
Info
•
Be sure to remove the lamp unit using the
handle. Be sure not to touch the glass sur-
face of the lamp unit or the inside of the pro-
jector.
•
To avoid injury to yourself and damage to the
lamp, be sure to carefully follow the steps
below.
•
Do not loosen other screws except for the
lamp unit cover and lamp unit.
•
Please refer to the installation manual in-
cluded with the lamp unit.
1
Press
on the projector or
on the remote control to put
the projector into the standby
mode.
•
Wait until the cooling fan stops.
Warning!
•
Do not remove the lamp unit from the
projector right after use. The lamp will
be very hot and may cause burn or in-
jury.
2
Disconnect the power cord.
•
Unplug the power cord from the AC
socket.
•
Leave the lamp until it has fully cooled
down (about 1 hour).
3
Change the air filter.
•
Change the air filter whenever you install
the lamp unit (see pages
61
and
62
).
4
Remove the lamp unit cover.
•
Turn the projector over. Loosen the user
service screw (for lamp unit cover) (
1
)
that secures the lamp unit cover. Press-
ing the tab, remove the lamp unit cover
(
2
).
1
2
Tab
Lamp unit cover
User service screw
(for lamp unit cover)
BQC-PGB10S//1
Lamp
unit
STANDBY button
AC socket
XV_Z10E_E_p52_62.p65
03.11.7, 4:19 PM
55
Summary of Contents for XV-Z10E
Page 71: ...Memo ...
Page 72: ......
