Preparation
9
Attaching and Removing
the Battery Pack
Attaching
1
Make sure that the Power
switch is set to OFF.
2
Align the
=
mark on the side of the
battery pack with the
=
mark on the
camcorder (
1
), and slide the battery
pack in the direction of the arrow
completely until it locks into place (
2
).
Removing
1
Make sure that the Power switch is set
to OFF.
2
Rotate the monitor section of the
camcorder (
1
), then press and hold the
battery release (
2
) as you slide the
battery pack in the direction of the arrow
and take it out (
3
).
Cautions:
•
BEFORE REMOVING THE BATTERY PACK,
ALWAYS STOP RECORDING OR PLAYBACK
AND TURN THE POWER OFF.
Removing the
battery pack while shooting or during playback
may damage the tape by causing it to wrap
around the video head drum or destroy the card,
rendering it unreadable and unwritable.
• Remove the battery pack from the camcorder if
you will not use the camcorder for a long period
of time.
• Make sure that the battery pack is firmly
attached during operation. If it is not, the battery
pack may come off or camcorder operation may
fall because of the poor contact pressure.
• To prevent damage to the battery pack when
removing, be sure to firmly hold the battery pack
while pressing the release.
• Use only SHARP model BT-L225 or BT-L445
battery packs with this camcorder. Use of other
batteries may create a risk of fire or explosion.
Battery release
Power switch
=
mark
VL-MC500S-GB-008-016
02.7.16, 3:23 PM
9
Summary of Contents for ViewCam VL-MC500S
Page 2: ......
