E-2
INSTALLATION INSTRUCTIONS
1. Remove all packing materials from the oven cavity. Check the unit for any damage, such as a misaligned
door, damaged door seals around the door or dents inside the oven cavity or on the door. If there is
any damage, please do not operate the oven until it has been checked by a SERVICE CENTRE
APPROVED BY SHARP and repaired, if necessary.
2. Accessories provided
1)
Turntable
tray
2) Roller stay
3) Operation manual and cooking guide
3. Fitting the roller stay and turntable. Locate the roller stay in the centre of the oven, then fit the
turntable on the roller stay. Make sure the turntable is centrally located and locked together. Never
operate the oven with out the roller stay and turntable.
4. The oven should not be installed in any area where heat and steam are generated. for example, next to
a conventional oven unit. The oven should be installed so as not to block ventilation openings. Allow at
least 15 cm. on the top, 5 cm. on the both sides and at the rear of the oven for free air space.
5. Neither the manufacturer nor the distributors can accept any liability for damage to the machine or
personal injury for failure to observe the correct electrical connecting procedure.
The A.C. voltage must be single phase
•
Thailand 220 V., 50 Hz.
6. Operate the oven from a general purpose domestic outlet. If a generator is used do not operate the
oven with NON-SINUSOIDAL outputs.
R-292 [EN] (01-18).indd EN-2
R-292 [EN] (01-18).indd EN-2
11/26/08 1:16:45 PM
11/26/08 1:16:45 PM