7
7-2
•
LPT Port
•
LPT Mode
•
Floppy Disk Controller
Security Menu
•
Set Supervisor Password
•
Password On Boot
•
Diskette Access
•
Boot Sector Virus Protection
Exit Menu
•
Get Default Values
•
Load Previous Values
When the system starts or resumes from Hibernation
If you have enabled
Password on boot
in the
Security
menu of the Setup Utility, the
system requires a password when you turn on the computer or the system resumes
from
Hibernation
.
If you enter the user password, you cannot read/write a floppy disk when the item
Diskette access
is defined as
Supervisor
in the
Security
menu of the Setup utility.
Setting/Changing the Password
If you lose your password, you will be unable to access the computer or
change the configuration. Make sure you select a password you will
never forget, and write it down and save it in a secure place. Otherwise,
you will have to contact your dealer for assistance.
1.
In the
Security
menu of the Setup Utility, select
Set Supervisor Password
or
Set
User Password
and press
Enter
.
2.
Type your current password, and press
Enter
. (If you set the password first
time, you need not perform this step).
3.
Type your (new) password (up to eight characters), and press
Enter
.
4.
Type the same password again, and press
Enter
.
5.
When the confirmation message appears, press
Enter
.
6.
Press
Esc
and select
Save Changes & Exit.
7.
Press
Enter
twice. The system restarts and asks the password you have set.
